What's everyone up to?

[WoodRay]

Well it's that time in that it's almost midwinter. Start posting up what you've been up to in the shed. Let's see your boats in their hibernation mode.

[rayza1]

Not too much happening, back from the Cape safe and sound. The cars in getting a new front left driveshaft courtesy of Holden. I have started reassembling a new (ish) 186 for Ronda. Apparently i'd left it behind at the last place i lived so I retrieved it and pulled it down...should be an ok motor

[RightyO]

work has come to a halt for winter.At Russel Island at the moment leaving on the barge Saturday but no set destination.

[Bob Vic]

A local bloke came to my workshop and turned my engine from 1 piece into a 1000 pieces. And then he went home. When I get sorted out, I'll need to get the carpet steam cleaned. Messy bugger.

[WoodRay]

Did I say I'm only good at pulling stuff apart Bob?

[Greg]

It's only an engine, Bob. It can't be that hard.

[Alan]

I know a few blokes that could have got it apart much faster, (but possibly more pieces than you want)

[Bob Vic]

He wouldn't let me use the rattle gun! No sense of adventure.

[screwit]

Ratbag is all sealed and assembled waiting for warm weather.
Invader may get some roves replaced and some spaces inserted to remove a hook in the over lap planks in the rear

[rayza1]

Bob.....you have a carpeted workshop??????? My floor is concrete and at times i wish it was dirt!!