Trailer needed for a 16' Wooden Inboard

[gwhastie]

I'm nearing completion of the 16' Crackerbox I've been building for the past 5 years and am looking for a good used inboard trailer that can carry a minimum of 550kg and is no wider than 1900mm (mudguards edge to edge) - the width is important as anything wider won't fit through the rear of my garage.

I'm preferably looking for one that is braked/registered and in reasonable condition but am happy to re-register and/or do some structural work on it if required.

I have a full set of construction plans for the matching Glen-L trailer but dont have the spare financial resources at the moment to have it professionally built.

Not looking to spend telephone numbers if
possible. All feedback welcome please. Happy to travel within a radius of 500km from Melbourne to pick one up.

Regards, Gary.

[Darren]

Hi Gary,
I have seen a few on FB marketplace lately.
Some may even come attached with a "project" where the trailer is 100 times better than the boat
Careful though I think its hard to register a home made trailer these days
Cheers
Darren

[gwhastie]

Thank you for the feedback Darren. I've pursued several of the project boats too, but unfortunately their trailers were wider than 1900mm so far.

[Darren]

Yes Gary, the width could present the problem of picking up a "project" boat