motor stringers for barellback 19 build
Posted: 23 Feb 2022, 11:01
dear all
i am a new member here and not familiar how this web site works... sooo..
I took on project to build a barellback 19 wooden speed boat ...
and so far i have completed frames and transome part of build...
next stage is a Motor stringers
plan calls for 13 foot 5 1/4 inch long overall
width is 2 inch and there i have my problem
plan also calls for 3/8 ply to be applied to one side....
and my question is why is this necessary......????
why not just make motor stringers thicker 9.53 mm thicker and make whole tickness 60.3 mm all one piece ????
any thoughts are appriciated
many thanks
Big Zed
i am a new member here and not familiar how this web site works... sooo..
I took on project to build a barellback 19 wooden speed boat ...
and so far i have completed frames and transome part of build...
next stage is a Motor stringers
plan calls for 13 foot 5 1/4 inch long overall
width is 2 inch and there i have my problem
plan also calls for 3/8 ply to be applied to one side....
and my question is why is this necessary......????
why not just make motor stringers thicker 9.53 mm thicker and make whole tickness 60.3 mm all one piece ????
any thoughts are appriciated
many thanks
Big Zed