Classic Australian Wooden Power Boat Association

Hi, I am setting up my ford 292 y block to take 3x holley 94 carbs sitting on a fenton 3 x intake manifold (similar set up to Hustler)
does anyone know where I can get 10 degree carb wedges?

Also the carby set up will be with a 3 carb progressive throttle linkage with the centre carb being the primary.
what size jets would I use for the primary plus what size for the secondary's?
any help would be gratefully appreciated..
regardsStuart

Don't like your chances, I built mine from scratch, have a couple of original boat ones and they are rough as guts so would not use them. With a bit of work Holley 94/Stromberg 97 carb spacers could be sliced up to suit. Flatattack or rocket could have em.

This one is on ebay but I can't get the link to work!!!!!!!!

http://www.ebay.com.au/itm/Holley-97-94 ... 4897.l4275

Good article here on setting up multiple 2bbl's http://www.stromberg-97.com/tech_center ... e_carb.asp

Carbie wedges 94-97 "Robbie Marine" will cast you a set. I had 6 made up and Marz had 3 made up for "HUSTLER".

thanks for the replies, I will contact"" robbies marine"
cheers...stuart