Invader
Re: Invader
Tomorrow driving up to Heathcote to pick up the fresh engine .700k round trip .
Need to start the swap eary as possible to have time to test and sort it all out .
Need to start the swap eary as possible to have time to test and sort it all out .
Re: Invader
Now that all is going well so far, on the trip back from Narrandera we broke a mud gard bracket so l have moved the gards up 100mm .
I have had some plates cut to make a 8o mm drop axle up with 40mm square solid.
Walking around the rear of the boat , some cracks were detected in the chrome of the steering quadrent .
Had a think about this and the avalability of a replacment and ha aranged to have a 20 mm S/S unit laser cut . Will have that tomorrow.
Working sometimes pay off !!!!!!
I have had some plates cut to make a 8o mm drop axle up with 40mm square solid.
Walking around the rear of the boat , some cracks were detected in the chrome of the steering quadrent .
Had a think about this and the avalability of a replacment and ha aranged to have a 20 mm S/S unit laser cut . Will have that tomorrow.
Working sometimes pay off !!!!!!
Re: Invader
Especially where you are working, Ross
Re: Invader
Greg due to the weight of it, l had work cut 2 -- 50mm circles out of the quadrent and is a bit lighter.
Just need to polish it up and fit it after cutting the cable grooves.
Just need to polish it up and fit it after cutting the cable grooves.
Re: Invader
Today l cut an axle and welded some 20mm drop plates to form a 80mm dropped axle for the trailer to make it easier get to boat off on the local boat ramps .
Managed to aline the stubs using two bare rims and strapped them to some heavy 5" channel.
When wheels dont osalate when axle is rotated after welding, it's all good .
Managed to aline the stubs using two bare rims and strapped them to some heavy 5" channel.
When wheels dont osalate when axle is rotated after welding, it's all good .
Re: Invader
Swaped the axle today, still have good clearance under the prop / rudder.
Amazing how much water was in the bearings after a week away from water .
Amazing how much water was in the bearings after a week away from water .
Re: Invader
Sanded the deck back and coated it.
Intend to add a few coats as it didn't get finished off as intended . Had some moisture get under the surface in a few spots. But had sanded out well .
To much of a hurry to get it going. !!!!
Intend to add a few coats as it didn't get finished off as intended . Had some moisture get under the surface in a few spots. But had sanded out well .
To much of a hurry to get it going. !!!!
Re: Invader
Yes Ross, you are one of those impatient skiff drivers now - always in a hurry ![Wink ;)](./images/smilies/icon_e_wink.gif)
![Wink ;)](./images/smilies/icon_e_wink.gif)
Re: Invader
Coated the deck again this morning finished at 9am.
Can said recoat after 4 hr , l recoated at 3 pm and it fried.
Can said recoat after 4 hr , l recoated at 3 pm and it fried.
Return to “Restoration Help and Advice”
Who is online
Users browsing this forum: No registered users and 119 guests