Page 1 of 1
prop set up
Posted: 08 Jun 2012, 20:57
by Greg
I'm sure we've had this discussion before, but how far away should the prop be from the rudder. I am talking specifically about a 6 cylinder skiff, but doubt if it would be that much different for any boat.
Greg
Re: prop set up
Posted: 09 Jun 2012, 08:53
by screwit
Greg, my skiff is 3" from tip of blade to rudder shaft and about 4" from hub to rudder
Ross
Re: prop set up
Posted: 09 Jun 2012, 13:46
by Doc
A closed fist between prop and rudder, don't forget 3/4" no more! between skeg and back of prop. To fit a prop puller. Prop nut should have a safety split pin or prop nut with additional lock nut. This is a requirement in boat racing today and could be a requirement for on water events later on.
Doc.