Classic Australian Wooden Power Boat Association

Ive been getting a 21ft 1958 Century Coronado back in the water
Ive given up trying to post a pic of it.

RightyO wrote:My searaft is home in bits but count help myself and called into Pro carb at Taree and bought a set of triple sidedraught carbs and a 12 port manifold they will be delivered to Coffs Harbour tomorrow. No cold snap up here .

Weber's Ken? Interested to see how it goes with jetting.

Found timing cover housing not concentric to crankshaft causing leakage past double seal set up. Took some realigning but all good now (static).

I've been flat out doing this,

Alan wrote:I've been flat out doing this,

ummm nothing?

I am back to working on my Seacraft ,I think the weber tuning is still a long way off , they have been jetted by Pro Carb to suit the 202 12 port the boat originaly had them but when the boat was put into storage someone borrowed them and the were not put back on the boat . I have rebuilt the trailer as it had rusted out , I am trying to decide weather to tip it over and paint the bottom , it is not bad but as the hull is stripped ,it may need a coat of yellow paint .

No can do Ken, Yellow is out Rayza bought all the stock a few years back

The weather gods look to be lining up for tomorrow. All cocooned up for paint and ready to go.

Colour on. That'll do. No more flaking paint...…………………………………….till next time haha.

My M1 Seacraft is starting to take shape ,l have setup the mechanical part now it’s time to drag out the sand paper and spray gun to finish the deck .