Hope the owner isnt a member of the club!!!!!!
Ross
Search found 1016 matches
- 14 Dec 2011, 11:35
- Forum: Do You Need This?
- Topic: Style?
- Replies: 20
- Views: 10380
- 11 Dec 2011, 22:22
- Forum: Main Room
- Topic: Boat ajustments
- Replies: 22
- Views: 14003
Re: Boat ajustments
Got back to the boat today and cut out the front bridge beam/deck in front of engine and trimmed the rear one down about 15mm in width to refit between the iner deck 140mm back down towards the back of the boat. Used the off cut to add to the front one each side and glued them on. then trimmed it to...
- 11 Dec 2011, 21:52
- Forum: Main Room
- Topic: A Tasmanian experience
- Replies: 625
- Views: 506326
Re: A Tasmanian experience
Chris, Hull looks great . What have you found so far under the paint ? How long did it take ?
What did you use to get it looking so nice . It does pay off to start with some thing in good condition, its the same with cars.
Ross
What did you use to get it looking so nice . It does pay off to start with some thing in good condition, its the same with cars.
Ross
- 07 Dec 2011, 08:51
- Forum: Main Room
- Topic: Boat licencing and regs in Victoria
- Replies: 10
- Views: 6507
Re: Boat licencing and regs in Victoria
This will get a lot of votes !!!!!!!!!
Ross
Ross
- 02 Dec 2011, 07:45
- Forum: Do You Need This?
- Topic: Climker in Sydney
- Replies: 0
- Views: 1563
Climker in Sydney
EBAY No 280782761561
Ross
Ross
- 30 Nov 2011, 07:52
- Forum: Do You Need This?
- Topic: Tandem trailer
- Replies: 0
- Views: 1491
Tandem trailer
Trailer suit 19ft- easy tow Ebay no 260904622688
Ross
Ross
- 28 Nov 2011, 08:18
- Forum: Do You Need This?
- Topic: Jet boat in melb
- Replies: 0
- Views: 1372
Jet boat in melb
Bondwood jet boat with holden 6 on ebay . no. 320798630999
Ross
Ross
- 23 Nov 2011, 07:53
- Forum: Wanted
- Topic: Chev 265 Small Block heads
- Replies: 2
- Views: 3911
Re: Chev 265 Small Block heads
I saw a set of offset scrip covers at Bendigo swap on the second level , thats what made me look at the site where I got the bell housing from under the table. there was a set of heads there on the table to but i didnt check if they were offset,
ross
ross
- 22 Nov 2011, 09:52
- Forum: Do You Need This?
- Topic: Dodge marine engine
- Replies: 1
- Views: 1785
Dodge marine engine
Flatt top dodge mairine engine ready to go with tripple SUs
Ebay no 160686272094 in Melb
Ross
Ebay no 160686272094 in Melb
Ross
- 21 Nov 2011, 19:51
- Forum: Main Room
- Topic: Boat ajustments
- Replies: 22
- Views: 14003
Re: Boat ajustments
Back at it today, steel frame made longer with a recess where the rear engine mount is . Bearer's are 2" narrower than std and engine ill not go between them. This part of the frame is plated both sides of the bearer as the timber bearers 3x3, are notched all most 1- 1/2 inches, this will give ...